Optical cable terminal fittings Pre-twisted tension clamp ADSS optical cable power fittings

ADSS pre-twisted tension clamp

ADSS optical cable pretwisted tension clamp

Installation pitch ≤100m Small pitch tension clamp for ADSS optical cable

Composition: U-shaped hanging ring, TC embedded ring, pre-twisted tension-resistant cable clamp, outer twisted wire

Pre-twisted wire material: aluminum-clad steel wire or galvanized steel wire

 

When the installation distance is more than 200m, use medium or large distance tension clamps

Composition: U-shaped hanging ring, TC embedded ring, PD hanging plate or PH/ZH hanging ring

Pre-twisted tension-resistant cable clamp has inner and outer twisted wires. Pre-twisted wire material: aluminum-clad

steel wire or galvanized steel wire

 

Features
①The product is easy to install and can be installed by hand without special installation tools. The installation

quality is guaranteed.

② Under the premise of ensuring that the gripping force on the optical cable is not less than 95% of the rated tensile

strength (CUTS) of the optical cable, the optical cable will not be damaged at the same time.

③The product is highly interchangeable and can be connected and matched with a variety of hardware, which increases

the scope of application.

④The product is made of aluminum-clad steel wire or galvanized steel wire, which has high-strength mechanical

properties and extremely high anti-corrosion properties.
Product selection instructions

①The product is based on ADSS rated tensile strength (RTS), operating tension, operating pitch, optical cable

Choose the appropriate tension clamp according to the outer diameter.

②Quantity configuration: 1 set of terminal towers/tower, 2 sets of tension towers/tower.

③The connecting parts should be matched appropriately according to the selected type of tension clamp.


Post time: Aug-05-2024