Aerial Cable Clamp JBG Series

https://www.yojiuelec.com/adss-pole-drop-anchor-clamps-overhead-cable-suspension-dead-end-tension-clamp-product/

JBG series Aerial Cable Clamp are used for LV-ABC lines with insulated neutral messenger.

• The  Aerial Cable Clamp of an aluminium alloy cast body and self-adjusting plastic wedges which tighten the conductor without

insulation damage.

• All parts of the clamp are resistant to corrosion, environmental effects and UV radiation.

JBG series Aerial Cable Clamp for all dielectric self-supporting cable (ADSS) are developed as a solution for aerial round fiber

optic cables of different diameters. These optical fiber fittings installed on short spans (up to 100 meters). ADSS strain clamp

is enough to keep the aerial bundled cables in tight strength position, and appropriate mechanical resistance archived by conical

body and wedges, which does not allow the cable to slip from the ADSS cable accessory The ADSS cable route may be dead-end,

double dead-ending or double anchoring.

The stainless steel bail allows installations of clamps on pole bracket.All the assemblies passed the tensile tests, operation experience

with temperatures ranging from -60℃ up to +60℃test: temperature cycling test, aging test, corrosion resistance test etc.

Application:

The wedge type anchor clamps are self-adjusting. While installation pulls the clamp upstream to the pole, using special installation

tools for optical fiber lines like pulling sock, stringing block, lever hoist to tensile the aerial bundled cable. The measure needed

distance from bracket to anchor clamp and start to lose the tension of cable; let the clamp’s wedges anchor the cable inside by degrees.

 

 


Post time: Oct-06-2021